MaxStream XStream X09-001 Series, Product Manual

Page: 57 / 64

XStream™ OEM RF Module – Product Manual v5.x00 [2006.02.24]
Interfacing Protocols
The Module Assembly supports the following interfacing protocols:
2
RS-2
• RS-232
• RS-485 (2-wire) Half-Duplex
• RS-485 (4-wire) and RS-42
32 Operation
DIP Swi al Port Connections tch Settings and Seri
Figure B ‐ 08. Figure B ‐ 09
settings are read and applied
Module Assembly
ontal line over pin name.)
RS ‐ 232 DIP Switch Settings Pins used on the female RS ‐ 232 (DB ‐ 9)
Serial Connector
DIP Switch
only while powering ‐ on.
Table B ‐ 05. RS ‐ 232 Signals and their implementations on the XStream
(Low ‐ asserted signals are distinguished by horiz
AT Command
DB-9 Pin RS-232 Name Description Implementation
Reference*
1 DCD DO3 Data-Carrier-Detect Connected to DSR (pin6)
2 RXD DO Received Data
Serial data exiting
the Module Assembly (to host)
3 TXD DI Transmitted Data
Serial data entering
into the Module Assembly (from host)
4 DTR DI3 Data-Terminal-Ready Can enable POWER-DOWN on the Module Assembly
5 G Groun Ground ND - d Signal
6 DSR Data-Set-Rea Connected DO3 dy to DCD (pin1)
7
© 2006 MaxStream, Inc. Confidential and Proprietary 57
/ CMD Request-to-S
Provides flow control or
Mode” on the Mo enab
DI2 end
les “Command dule
8 DO2 Clear-to-Se Provides nd flow control
9 DI Ring Indicato
ower input that o the
tive lead of the ctor
- r
posi
Optional p is connected internally t
front power conne
* Th ommand Reference as associative tag whe commands
odule. “DI” stands for Data Input and “DO” for Data Output.
e AT C provides n using the AT to program the
M
Downloaded from Elcodis.com electronic components distributor