9XTend™
OEM
RF
Module
–
Product
Manual
v1.2.4
©
2005
MaxStream,
Inc.
Confidential
&
Proprietary
43
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiving module.
•
Connect the equipment into an outlet on a circuit different from that to which the receiving
module is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Antenna Warning
WARNING: This device has been tested with Reverse Polarity SMA connectors with the
antennas listed in Tables A.1 – A.7 of Appendix A. When integrated into OEM
products, fixed antennas require installation preventing end-users from replacing
them with non-approved antennas. Antennas not listed in the tables must be
tested to comply with FCC Section 15.203 (unique antenna connectors) and Section
15.247 (emissions).
Limited Modular Approval
Power output is conducted at the antenna terminal and can be adjusted from 1 mill-watt to 1
Watt at the OEM level. This is an OEM RF Module approved for Limited Modular use operating as a
mobile transmitting device with respect to section 2.1091 and is limited to OEM installation for
Mobile and Fixed applications only. During final installation, end-users are prohibited from access
to any programming parameters. Professional installation adjustment is required for setting
module power and antenna gain to meet EIRP compliance for high gain antenna(s).
Final antenna installation and operating configurations of this transmitter including antenna gain
and cable loss must not exceed the EIRP of the configuration used for calculating MPE. Grantee
(MaxStream) must coordinate with OEM integrators to ensure the end-users and installers of
products operating with the module are provided with operating instructions to satisfy RF
exposure requirements.
The FCC grant is valid only when the device is sold to OEM integrators. The OEM integrators are
instructed to ensure the end-user has no manual instructions to remove, adjust or install the
device.
