MaxPro MPFS250VQ, User Manual

Page: 6 / 71

11/3 Sheet Finishing Sander MPFS250VQ User Manual
6
Before the first use
Remove the finishing sander and all accessories out of the packaging and check all parts for damage in
transit.Keep packaging material out of reach of children. There is risk of suffocation.
Attaching Sanding Paper
Choose the sanding paper according to the material being worked. Use sanding paper with a 40 resp, 60
grain for rough sanding and on uneven surfaces. Use the finder grain of 120 for smoother finish.
1. Press the button (5) inwards in order to lift up the clamping bracket.
2. Attach the sanding paper on the sanding plate and make sure the holes on the sanding paper fit with
openings on the base plate.
Only this way the sanding dust can be extracted through suction ducts in
the sanding plate.
3. Firmly press sanding paper down on the sanding plate.
Selecting the Sanding paper
Always use abrasive papers suited to the material you want to sand. Then papers must have correct grain
size.
Depending on grain size there are degrees of coarseness. The coarseness is specified by a number on the
back of papers. The higher the number is, the finer the grain.
It is important to use the right paper for each job. For rough sanding use grain sizes up to 80, for soft wood
as larch, pine or spruce use papers from 60grit to 150grit.For dense
hardwood as beech or maple, the grain sizes with up to 220 can be used.
Assembling/Disassembling/Emptying the Dust Bag
Always use the dust bag when sanding
1. Place the dust bag onto the provided exhaust
connection.
Push the box up to the end into housing.
2. To remove the dust collection box, just pull the box
outwards.
Preferably clean the dust collection box
and the exhause connection in the housing after each
use.
By doing this the dust collection box can be
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(5)
1
2
4 3
OPERATING INSTRUCTION
GB