9
Chapter 2 General Safety Information
3
、
Optical Operating Instructions
We strongly recommend that you read the following procedures before
operating the laser:
1
、
Never look directly into the laser output port when the power is turned on.
2
、
Avoid positioning the laser and all optical output components at eye level.
3
、
Ensure that all personal protective equipment is suitable for the output power
and wavelength range of the laser.
4
、
Do not install or detach cutting heads or collimators when laser is active.
5
、
It is forbidden to turn on the laser during the mounting of fiber or cutting
head. Carry out commissioning, calibration and focusing at low output power
and then increase the output power gradually when the calibrating and focusing
work is done.
6
、
Marking on highly reflective materials is feasible, but you must make the
laser out of focus, or else you may damage the laser.
7
、
For collimated outputs, maintaining a clean output lens is essential. Always
close (re-cap) the collimator after use. Do not touch the output lens and do not
clean it with any solvents.Cleaning with the special solvent and cleaning buds is
allowed as described later on in th is manual.
WARNING:
◎
Make sure that the individual protective equipment meets the output power
and wavelength range of the laser.
◎
Never look directly into the optical fiber or the collimator, and use appropriate
laser safety eyewear when operating this device.
◎
Optical damage may result from failure to comply with the above instructions.
Such damage is not covered by the warranty.
