9
Chapter 2 General Safety Information
and wavelength range of the l aser.
4.Do not install collimators when the laser is active.
5.It is forbidden to turn on the laser during the mounting of fiber or cutting head.
6.For collimated outputs, maintaining a clean output lens is essential. Always
close (re-cap) the collimator after use. Do not touch the output lens and do not
clean it with any solvents. Cleaning with the special solvent and cleaning buds is
allowed as described later on in th is manual.
WARNING:
◎
Make sure that the individual protective equipment meets the output power
and wavelength range of the laser.
◎
Never look directly into the optical fiber or the collimator, and Use appropriate
laser safety eyewear when operating this device.
◎
Optical damage may result from failure to comply with the above instructions.
Such damage is not covered by the warranty.
CAUTION:
◎
Use of controls or adjustments or performance of procedures other than those
set forth in this User’s Guide and related documents may result in hazardous
radiation exposure.
4.Operation Environment Requirements
We strongly recommend that you read the following procedures before operating
the laser:
1.Do not expose the device to a high moisture/high temperature environment .
Install the laser in the cabinet with the function of temperature-humidity control