To exit group scan mode, press and hold
SCN
for 2 seconds.
(See "Scan Resume Delay" for additional information
regarding the pause).
Transmitting While Scanning
When a message is transmitted while scanning (i.e. the
words
"IN SCAN"
show on the display), dealer program-
ming determines if it is transmitted on the "Last Active"
(floating) or on a pre-set "home" system and group. The
following describes operation for each configuration.
First Available System Scan
When you are out of range of a system when trying to
transmit, first available system scan (FASS) will scan
all systems programmed and look for the first system that
is in range of the radio.
To enter first available system scan (FASS), rotate the
on/off-volume control counter-clockwise to detent, shutting
off power to radio. Press and hold the
SCN
key on the
DTMF microphone while turning the radio power back on.
The word
"FASS"
will show in the upper center portion of
the radio display. When you attempt to transmit and the
selected system is out of range, the radio will emit a short
tone indicating the system is out of range and FASS mode
has started. When the radio detects a system in range,
scanning will stop and the radio will emit a short series of
tones (auto ringback tones) to indicate a system is in range.
Normal operation may resume. To exit the scan initiated by
FASS mode, press and hold
SCN
for 2 seconds. To exit
FASS mode, turn the radio off and then back on.
34
