Scan Modes
(using Model TMA-4474 )
Manual System Scan
System scan is initiated by pressing
SCN
,
then
SYS.
Scan
mode is indicated by the word
"SCAN"
shown in the upper
center portion of the display. When scanning is actually
occurring, the words "IN SCAN" show in the display in
place of the unique group identifier. In addition, the system
numbers are incremented. Scanning is sequential through all
trunking and conventional systems, unless they are locked
out of scan as described under "System Lockout". When an
incoming call is detected, scanning stops and the call is
received. The display will indicate the system and group
identifier from which the call was received and the word
"SCAN"
in the upper center portion of the display. When
the incoming call is complete, scanning resumes after a pre-
determined pause. To exit scan mode, press and hold
SCN
for 2 seconds. (See "Scan Resume Delay" for additional
information regarding the pause).
Manual Group Scan
To initiate manual group scan press
SCN
,
then
GRP
.
Scan mode is indicated by the word
"SCAN"
shown in
the upper center portion of the display. When group scan is
actually occurring, the words
"IN SCAN"
appear in the
display in place of the unique group identifier. Group scan
occurs only on those groups enabled by your Maxon Dealer
for the selected system. When an incoming call is detected,
scanning stops and the incoming call is received. The display
changes to indicate the group identifier on which the call was
received and the word
"SCAN"
in the upper center portion
of the display remains. When the incoming call is complete,
after a brief pause, scanning resumes.
33
