Installation Safeguards
Some electronic fuel injection, anti-skid breaking systems,
cruise controls, and vehicle alarms may be prone to interfer-
ence from radio frequency energy or may malfunction due to
a lack of protection from RF energy. If the vehicle contains
such equipment, consult the dealer or factory and enlist their
help in determining whether the electronics equipment in the
vehicle will operate properly when the radio is transmitting.
• Select a location for the radio which allows the user to see
and easily reach the microphone and radio controls.
DO NOT
install the unit where it would interfere with the
proper operation of automatic collision protection
devices (air bags).
DO NOT
install the unit where it would likely cause injury
in case of accident.
• After selecting a location for the radio, hold the mounting
bracket in place. Using the bracket as a template, mark
with a pencil the spots where the bracket securing
screws will be located.
• Before drilling holes in the vehicle, verify that there is
nothing that could be damaged or get in the way by
drilling and putting screws in this location.
NOTE:
It is better to use existing passages in the dash-
board, trunk, and floor for the routing cable, thus avoiding
excessive drilling.
NOTE:
This radio is not intended for operation in a positive
ground vehicle.
A suitable antenna must be purchased for use with the radio.
Consult your Maxon Dealer for recommended Maxon
antennas.
3
