Service Manual
SP - 1402
Page 19 of 35
PLL Alignment
TX VCO
a)
Select channel 1. (440.025MHz)
b)
Set the PTT switch to on. Check that the VCO tuning voltage at TP1 is 0.7~1.0V. (CV1)
c)
Set the PTT switch to off. Select Channel 8. (469.975MHz)
d)
Set the PTT switch to on and check that the voltage at TP1 is 4.0~4.5V.
e)
Set the PTT switch to off.
RX VCO
a)
Select channel 1. (440.025MHz)
b)
Check that the VCO tuning voltage at TP1 (Please see fig.3) is 0.7~1.0V. (CV901)
c)
Select channel 8. (469.975MHz)
d)
Check that the voltage at TP1 is 3.5~4.0V.
Transmitter Alignment
TCXO
a)
Select channel 1. (440.025MHz)
b)
Set the PTT switch to on.
c)
Using the frequency counter, adjust the TCXO (RV1), so that the transmit frequency is
/- 300Hz of the required frequency.
d)
Set the PTT switch to off.
If no further alignment is to be carried out, it may be necessary to reset the squelch.
Power
a)
Select channel 1. (440.025MHz)
b)
Set the PTT switch to on.
c)
Adjust the RV4 max(clockwise),RV5 to get Power 5W
Summary of Contents for SP-1102
