Mounting Instructions
CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
Stem/Pendant Mount:
Operating Instructions HL Series
MaxLite LED Linear HighBay Fixtures
®
Locate a secure structural member and inspect it for
damage. Knockout two (2) 3/8” KO.
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
Page: 5
REV: 08/13/18
Knockouts
Feed the stems into the two (2) knockout holes
and secure them with nuts.
Surface Mount:
Locate a secure structural
member and inspect it for
damage. Secure the top mounting
bracket onto the flat surface using
four (4) #8 screws. Use the drill
pattern figure shown in
Fig. 1
.
Using the cord grip provided, securely
attach the input wires onto the cover
plate, as shown in
Fig. 2
. The cord grip
can also be attached to the either side
of the top mounting bracket using the
knockout holes for daisy-chain
applications.
Attach the base bracket onto the
fixture by inserting four (4) M4
screws, as shown in
Fig. 3
.
Slide the assembled fixture onto the surface
mounted top mounting bracket. Secure the
fixture to the bracket using the two (2) screws
shown in
Fig. 4
. Wire the input wires to the
fixture.
Attach the cover plate by tightening three (3) M4 screws
as shown in
Fig. 5
.
