Operating Instructions HL Series
MaxLite LED Linear HighBay Fixtures
®
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
Page: 6
REV: 08/13/18
Driver Access Instructions
Remove the two (2) bottom center screws
securing the center driver plate to the fixture.
Slide the driver plate to the left or right
depending on the orientation of the fixture,
see
Fig. 1
.
The center plate will hinge from one side, as
shown in
Fig. 2
. allowing access to the driver.
Once repairs are done, slide the plate back
into place and replace the two (2) screws.
Lens Removal Instructions
Remove the two (2) bottom screws closer to the
center of the fixture. Slide the lens to the right
towards the center of the fixture, freeing the left
side of the lens, as shown in
Fig. 1
.
Remove the lens to have access to the LED
board, as shown in
Fig. 2
. Once repairs are
complete, slide the lens back into place and
replace the two (2) screws.
LED Board
Wire Guard Instructions
Using the four (4) included M4 machine screws and
four (4) included bracket clips (refer to
Fig. 1
), snap
the clips onto the wire guard, and secure the clips
to the fixture with the screws (
Fig. 2
).
