© Copyright 2019. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
Page: 2
REV: 04/23/19
General Wiring Diagram
CAUTION:
Turn off electrical power at
fuse or circuit breaker box before wiring
fixture to the power supply.
Connecting panels to AC source supply:
All units must be individually connected to
the AC supply.
Black = Line
White = Neutral
Green = Ground
Installation & Operation
1.
Remove the three (3) set screws at the bottom of
the fixture and remove the base plate (see
Fig. 1
).
2.
Place the anchor bolt assembly (three (3) anchor bolts
secured to the pad plate with nuts on either side) over the
conduit and secure for the concrete pour. Ensure that the
pad plate is flush with the concrete surface, and that the
assembly will not dislodge during the concrete pour (see
Fig. 2
).
3.
Pour concrete while ensuring that the pad plate is as level
as possible. Allow the concrete to cure.
4.
Once the concrete is dry, place the base plate onto the
anchor bolts and secure it with nuts and washers (see
Fig. 3
).
5.
Connect the power supply wires from the conduit to the
input wires from the bottom of the fixture according to the
wiring diagram.
6.
Mount the fixture on the base and secure it with the
three (3) set screws removed from the bottom of the
fixture in step 1.
(+) LINE
(-) COMMON
GROUND
GREEN
WHITE
BLACK
Light
Fixture
Base
Set Screw
Anchor Bolt
Conduit
Pad Plate
Base
Nut
Washer
Operating Instructions
LED Bollard - BL-CL2RD Series
MaxLite
Classic Round Bollard 42” Dome Top
®
