Copyright maxitrak 2010
8.
Take the four slide bars and fit them to the back covers of the cylinders, M4 hex bolts. The
motion brackets can now be fitted to the other end of the slide bars, using M3 round head screws.
Check you have left and right hand correct, the curved top of the motion bracket should be
horizontal ready to bolt to the footplate.
9.
You can now put the footplate on left side. M2 hex screws in the rear buffer beam and the
motion bracket, M3 round head in the front buffer beam. Check the holes line up for the hand
pump bracket, drill or file out the footplate to fit, check this with the hand pump its self as well.
Before fitting the right footplate bend up the whistle pipe (E) and fit it to the whistle valve, so as to
fit through the cut out in the footplate behind the reverser stand.
10.
The bypass valve and axle pump pipe work can now be fitted to the right side of the engine,
bend the feed pipe to get to the check valve on the right of the regulator. The return pipe from the
bypass valve (A) can be fitted but the other end can be left until the tank is in place.