3
5
4
6
7
2
1
13
12
model no. 058-9372-4 | contact us 1-888-670-6682
• It is recommended that an automatic in-line filter-regulator-l
ubricator be
used and be located as close to the tool as possible.
• If a filter-regulator-lubricator is not installed, place up to
6 drops of
pneumatic tool oil directly into the air inlet plug before each use.
• If a filter-regulator-lubricator is installed, keep the air fil
ter clean. A dirty
filter will reduce the air pressure to the tool, which will c
ause a reduction
in power, efficiency, and general performance.
AIR TOOLS
Read this Instruction Manual thoroughly or have the tool
operators read thoroughly before using the tool.
• Read all safety rules and precautions (see “Safety Guideline
s” section) at
the beginning of this manual.
• Always inspect the air tool prior to each use in order to
– Ensure proper use of power source.
– Determine whether the tool is in proper working order.
• Drain the compressor tank daily. Water in the air supply line
will damage
the tool.
• Clean air inlet and filter weekly.
• Line pressure should be increased to compensate for unusually
long air
hoses. The hose diameter should be 3/8" ID. The fittings must
have the
same inside dimensions.
• Ensure that the trigger is not pressed while connecting the t
ool to the air
supply.
• Ensure the air supply is clean and is maintained at the regul
ated pressure
of 90 PSI and recommended air flow rate (see section “Technical
Specifications”).
WARNING!
Potential hazard that could result in serious injury or
loss of life.
• Do not exceed the maximum and minimum pressures.
The use of the wrong pressure (too high or too low)
or the use of unclean air may cause excessive noise
and rapid wear, which will shorten the life of the tool.
• Keep hands and other parts of the body away from
the work area when connecting the air supply. Failure
to comply could lead to serious injury or loss of life.
• Make sure all connections in the air supply system are
sealed in order to prevent air from leaking. Failure to
comply may result in injury or damage to
equipment.
CAUTION!
Potential hazard that may result in injury or damage to
equipment.
MAXIMUM® Air-powered
Ratchet
Description
No.
1
2
3
4
No.
5
6
7
Filter
Cut-off valve
Air compressor
Air system
• Always use clean, dry, regulated, compressed air at the reco
mmended
pressure and specific flow rate (see “Technical Specifications” se
ction).
Lubricator
Regulator 0-123PSI
(0 to 8.5 bar)
Description
Air hose
WARNING!
Potential hazard that could result in serious injury or
loss of life.
• Do not use the tool if it is not in proper working order.
• Do not use oxygen or any other combustible or bottled
gas to power this tool.
• Do not use this tool in the presence of any flammable
liquids or gases.
• Keep hose away from heat, oil, and sharp edges. Check
hose for wear and tear, and ensure that all connections
are secure. Failure to comply could lead to serious
injury or loss of life.
TM
