17
16
model no. 058-9372-4 | contact us 1-888-670-6682
Storage
If it is necessary to store the tool for an extended period of time, apply a
generous amount of lubrication before storing. The tool should be allowed
to run for approximately 30 seconds after lubricating, in order to ensure
that the lubrication is uniformly distributed throughout the tool.
• Lubrication: If the Air-powered Ratchet and the
compressor are not equipped with an in-line
lubrication system, place up to 6 drops of
pneumatic tool oil into the air inlet before each
work day or after every 2 hours of continuous
use, depending on the characteristics of the
workpiece.
• Do not use worn or damaged sockets. Inspect the tool periodic
ally, and
replace the worn or broken parts in order to ensure that the tools are
operating safely and efficiently.
• Disconnect the tool from the air supply when it is not in use
.
• Loss of power or erratic action may be due to the following
- Excessive drain in the air line.
- Moisture or restriction in the air pipe.
- Incorrect size or type of hose connector. Check the air supply and follow
instructions.
General inspection-
free movement
Trigger, spring,
safety mechanism
None
X
Worn or broken
parts
X
X
Replace worn or
broken parts
X
Lubrication
See below
Pneumatic
X
MAINTENANCE
REQUIRED
DESCRIPTION
TOOLS OR
MATERIALS
REQUIRED
MAXIMUM SERVICE INTERVAL
Each use or
every 2 hrs
Monthly
As
needed
In-depth inspection
DANGER!
Potential hazard that will result in serious injury or
loss of life.
• Keep children away from the work area.
Do not allow children to handle power tools.
WARNING!
Potential hazard that could result in serious injury or
loss of life.
• Disconnect the tool from the air supply before changing
accessories, servicing, or performing maintenance.
• Do not use the tool before replacing or repairing any
damaged parts or accessories.
• Use only recommended and properly rated replacement
parts. Non-authorized parts may be dangerous. Failure
to comply could lead to serious injury or loss of life.
tool oil
CAUTION!
Potential hazard that may result in moderate injury or
damage to equipment.
• Store the tool in a clean and dry environment. Failure
to comply may result in injury or damage to
equipment.
TM
