20
21
CHARGING PROCEDURE
• Connect the plug cable to the charger, and then plug into
an appropriate outlet before inserting battery pack (Fig.
C). All three charging lights will be on for two seconds and
then off.
• Insert the battery pack into the charger, making sure the
pack is fully seated in the charger (Fig.D). During the
charging process, the charging lights will indicate the
charging status as follows:
- Less than 30% charged: all three charging lights will
blink in sequence.
- Less than 60% charged: one light will stay on, while the
other two lights will blink in sequence.
- Over 60% charged: two lights will stay on, while the
remaining light will blink continuously.
- Fully charged: all three lights will remain on
continuously.
• The charging process will be last approximately 35 minutes
(2.0 Ah battery pack) or 65 minutes (4.0 Ah battery pack)
and permanent lighting of all three charging lights will
indicate charging is complete.
CHARGER DIAGNOSTICS
The charger is designed to detect certain problems that can
arise with battery packs.
• When the charger detects a battery pack that is
overheated, all three charging lights will blink at the same
time. Please remove the battery and allow it to cool down
for 15—30 minutes and re-insert.
OPER
A
TING INS
TRUCTIONS
CAUTION!
• Before attempting to charge the battery, check the charger
and the battery to ensure the charging equipment matches
the battery supplied. The components are all labeled with
component numbers.
• The rechargeable battery is not fully charged on leaving the
factory. Charge the rechargeable battery before first use.
• Recharge discharged batteries as soon as possible after use
or battery life may be greatly diminished. For longest battery
life, do not discharge batteries fully.
• The working temperature of the charger is 4-40°C
(40-104°F).
• When the charger detects a malfunction in the battery, two charging lights will blink
at the same time. Please remove the battery and allow it to cool down for 15—30
minutes. Then re-insert the battery pack into the charger. If two charging lights still
flash, the battery may require service.
• When the charger detects a malfunction of the charger
itself, three charging lights will blink at the same time.
Please remove the battery pack and unplug the charger for
at least 2 minutes. After 2 minutes, plug charger back in
and re-insert the pack into the charger. If all three charging
lights still blink at the same time, the charger may require
service.
TRIGGER SWITCH
The saw is controlled by a trigger switch and lock off button.
The lock off button must be pressed down before the trigger
switch will turn the saw on. Releasing the trigger turns the saw
off (Fig. E).
REMAINING POWER INDICATOR
If the saw is turned on, the remaining power indicator lights for
5 seconds and the battery’s remaining power can be checked
(Fig. F).
LED INDICATOR
REMAINING POWER STATUS
1
0–25%
2
25–50%
3
50–75%
4
75–100%
OPER
A
TING INS
TRUCTIONS
NOTE:
Charging times maybe longer depending on the surrounding
temperature and battery conditions.
NOTE:
This tool has no provision to lock the switch in the ON
position. The saw should never be locked ON by any other means.
NOTE:
This tool is equipped with an electric brake. When the brake
is functioning properly, sparks may be visible through the vent slots
in the housing. This is normal and is the action of the brake.
model no. 054-8355-0 | contact us 1-888-670-6682
Summary of Contents for 054-8355-0
Page 1: ......
