FIG.6
FIG.5
FIG.1
FIG.2
FIG.4
FIG.3
3
MACHINE OPERATION
1
ST
STEP: LOWER DRUM FILLING
• Unhook the closing devices (fig.1);
• Lift the upper cover (fig.2);
• Fill the lower drum with about 2 litres of clean water (fig.3)
• Reposition the cover by paying attention to the drum level
indicator. It must be is in the front part (fig.4)
IMPORTANT: to avoid motor damages during the
suction check that the liquid contained in the drum
does not exceed the level indicated on the drum
itself
(MAX) (fig.4) otherwise we recommend
emptying the drum.
2
ND
STEP: TANK FILLING
• Remove the plug when the machine is cold and not under
pressure (fig.5), fill the tank with water by using the suitable
bottle supplied through the mouth of the safety plug (fig.6)
then close by screwing and pressing the plug downwards.
• When the water is finished in the tank, the “f” light will light
up and at the same time there will be an acoustic signal; in
this case immediately turn off the boiler by pushing button
“A”, eliminate any pressure residue by pressing the steam
button on the handle (fig.13 page 5).
• At this point disconnect the feeding cable, then eliminate
any pressure residue by slightly unscrewing the safety plug
(BE CAREFUL OF ANY STEAM THAT MAY SPURT OUT)
• Once there is no residue pressure, wait 5/10 minutes and
repeat from point 1.
WARNING: Do not turn on the boiler if it is empty,
you could may damage the resistance (not covered by
warranty). Do not touch and/or open the safety plug
when the boiler is on or still under pressure! danger
of burns!
WARNING: Fill the lower drum only with water.
Do not use fragrances-essential oils different
from the ones approved by the Manufacturer.
They may damage the drum.
Empty and wash the drum after each use.
To clean the drum, use natural soap and rinse
with abundant water.
