C
B
A
NO!
NO!
OK
C
A
B
D
8
COMPONENTS OF FILTER AND SEPARATOR
A. Molecular separator.
B. Knurled screw.
C. Filter.
D. Motor support.
ROUTINE MAINTENANCE
MOTOR SUPPORT (D)
It is located under the upper cover. For the cleaning at first we
recommend disconnecting the device. Use only a wet cloth. Do not
use direct water jets (i.e.: shower, tap, etc.).
THE MACHINE CAN BE TIPPED TO ONE SIDE ONLY FOR
THIS FUNCTION (DO NOT OVERTURN THE MACHINE
FOR ANY REASON!)
FILTER AND SEPARATOR
Once the filter is removed, you can see the “molecular separator”
(A). Both the filter and the separator must be washed separately
with water. To remove them, contact an authorised service centre.
NOTE FOR THE TECHNICIAN AT THE SERVICE CENTRE:
To remove filter (C) remove the safety screw by turning it until it
comes away. To remove separator (a) unscrew knurled screw (B) and
remove from the housing. Be careful on re-inserting it as it has a set
housing. Screw the knurled screw clockwise without tightening it
too much. Do not use the machine if the plastic filter is not inserted
or if it is without the “molecular separator”.
SPONGE FILTER
The filter cover (A) is located in the rear part of the machine and can
be removed by sliding it upwards.
Once the filter cover has been removed, you can reach the silencer
filter (B) which is located in the motor air outlet (C). We recommend
cleaning it periodically by washing it with water.
A. Filter cover
B. Silencer filter
C. Air outlet
