MAXIDRY MAXIMD200, Installation Manual, Page: 29 / 64

113274 - 1 25
2. Electrical Service Specifications
5/16/11
IMPORTANT:
The dryer must be connected to the electric supply shown on the data label that is
affixed to the right electrical control panel .
WARNING: 208 VAC AND 240 VAC ARE NOT THE SAME . Any damage done to dryer
components due to improper voltage connections will automatically VOID THE
WARRANTY.
NOTE:
The manufacturer reserves the right to make any changes in specifications at any time without
notice or obligation.
NON-TILT (GAS – REAR EXHAUST)
7.5 hp Blower Motor / 3 hp Drive Motor
ELECTRICAL SERVICE SPECIFICATIONS (PER DRYER)
IMPORTANT :
NOTES : A.
B.
C.
208 VAC AND 230/240 VAC ARE NOT THE SAME. When ordering,
specify exact voltage.
When fuses are used they must be dual element, time delay, current
limiting, class RK1 or RK5 ONLY. Calculate/determine correct fuse value,
by applying either local and/or National Electrical Codes to listed
appliance amp draw data.
Circuit breakers are thermal-magnetic (industrial) motor curve type ONLY.
For others, calculate/verify correct breaker size according to appliance
amp draw rating and type of breaker used.
Circuit breakers for 3-phase (3ø) dryers must be 3-pole type.
SERVICE
VOLTAGE
PHASE
WIRE
SERVICE
APPROX.
AMP DRAW
CIRCUIT
BREAKER
60 Hz 50 Hz
208 3ø 3 / 4 36.2 — 60
220 3ø 3 35.2 — 60
240 3ø 3 34.2 — 60
230 3ø 3 — 35.1 60
380 3ø 3 / 4 — 20.2 30
400 3ø 3 / 4 — 20.0 30
416 3ø 3 / 4 — 19.9 30
460 3ø 3 18.1 — 30
480 3ø 3 18.1 — 30
575 3ø 3 14.9 — 20