MAXIDRY MAXIMD200, Installation Manual, Page: 17 / 64

113274 - 1 13
a. Reassembly Instructions For Non-Tilt Steam Dryers:
Lift the tumbler section onto the base.
1) The dryer has four (4) support posts assemblies, which are located in each corner of the base. On
top of each post assembly is a clevis block, which must be bolted to the tumbler section. Use the
4-1/2” diameter x 1-1/8” long bolts and lock washers to bolt each clevis block to the tumbler section.
(Refer to
View 1
on the previous page.)
2) Tumbler power cable reconnection:
a) A plug and cable is located in the right of the base. This
must be
lifted up and reconnected into
the mating socket located at the bottom of the right tumbler section.
b) Pull the tumbler section power cable up from the left side of the base through the hole in the
bottom of the tumbler section. Reconnect the wires of this cable into the 2-inch x 4-inch (5.08
cm x 10.16 cm) tumbler junction box located at the bottom of the tumbler section. (Refer to the
illustration
on the previous page.)
c) Drop the control cable connector from the rear right side of the tumbler section into the base.
Reconnect the industrial grade plug in to its mating socket.
3) Bolt the 20-inch (50.8 cm) diameter exhaust duct transition piece to the dryers rectangular exhaust
duct. The exhaust duct exits the dryer from the rear of the base. (Refer to the
illustration
on the
previous page.) Use the 1/4-20 self-drilling screws supplied with the dryer.
4) If a steam dryer is shipped in two (2) pieces, the steam coil may have been removed from the top of
the tumbler section and shipped with the base. If this is the case, lift the steam coil on to the top of
the tumbler section with the steam pipe connections facing towards the right side of the dryer and
bolt the coil to the top of the dryer with a 1/4-inch hardware supplied. There are three (3) panels that
cover the front, right side, and rear of the steam coil. Fasten these in position also.