Maxey Moverley Limited, 6 Broad Ground Road, Lakeside, Redditch, Worcestershire, B98 8YP
Web: www.cctvrepairs.com ● Email: [email protected]
Tel: 01527 522299 ● Fax: 01527 522588
Issue 1.1
| Page 4
Quick Reference Guide
Vista PowerDome
3.
Addressing
The receiver card mounted on the Power Domes pan/tilt contains a multi position DIP switch, as
seen below. Use the switch to assign a camera number to the Power Dome.
3.1
Dip Switch Positions & Equivalent Values
To program the receiver’s site number on the DIP switch use the table below:
Dip Switch Position Number
1
2
3
4
5
6
7
8
9
10
11
12
Equivalent Value
1
2
4
8
16
32
64
128
256
512
x
x
If you use the PowerDome with coaxial UTC telemetry, we recommend that you set the address
especially if you plan to add a VPD-ALM16 alarm module.
If you use RS485 directly from a Vista NPX/KBD/J3De or VPD-KBD keyboard that is also controlling
multiple Vista Triplex Columbus digital recorders or VDC1604 matrix units, address domes attached
to the units as follows:
•
Unit with BaxNet address 1: 1 through 16
•
Unit with BaxNet address 2: 17 through 32
•
Unit with BaxNet address 3: 33 through 48
•
Unit with BaxNet address 4: 49 through 64
For units with any other BaxNet address, domes should be numbered 1 through 16 and you should
use only one keyboard.
When you use UTC control, each receiver needs to tune to the transmitter. Select each dome in turn,
and pan left and right until the dome moves. This should take about 5 to 10 seconds.
