Maxent MX-27X1, Owner'S Manual

Page: 74 / 95

74
Appendix
Install the LCD monitor onto the wall mount bracket
by placing the four pegs located on the rear of the
LCD monitor inside mounting holes on the Wall
Angle Modules and making the four pegs firmly
seated in the holes.
Note: Actual rear cabinet may vary from the drawing.
Remove the pedestal table-top stand from the LCD
monitor Screw the four pegs the rear of the LCD
monitor.
You can adjust the mounting direction and
inclination angle (0, 5, 10, 15 degrees) by
adjusting the screws position on the Wall
Mounting Angle Module.
0 5
10
15
Wall mount bracket is an optional accessory, please
contact your local sales agent for more information.
This type of equipment is to be installed by qualified
installers, please contact with authorized dealer for
installation.
4
7
Insert the two Rubber Covers to the holes at the
bottom of the LCD monitor after removing the
pedestal table-top stand from the LCD monitor.
5
6
Please make sure that your wall is capable of supporting
this wall mount and the LCD which can easily weigh over
60 kg (132.3 lbs.).
7
8