8
Connecting power supply
1.
Put the connector of the power cord into the
AC
(AC
inlet) of the projector.
2.
)LUPO\SOXJWKHSRZHUFRUG¶VSOXJLQWRWKHRXWOHW,QD
couple of seconds after the power supply connection,
the
POWER
indicator will light up in steady orange.
Please remember that when the DIRECT POWER ON
function activated, the connection of the power supply
make the projector turn on.
WARNING
Ź'RQRWFRQQHFWWKHSURMHFWRUWRDSRZHUVXSSO\ZKLOHQROHQV
unit is attached to it.
Ź
Please use extra caution when connecting the power cord, as incorrect or
IDXOW\FRQQHFWLRQVPD\UHVXOWLQ¿UHDQGRUHOHFWULFDOVKRFN
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
WKHRXWOHWDQGFRQQHFWRUVORRVHQWKHFRQQHFWLRQRUUHVXOWLQ¿UHHOHFWULF
shock or other accidents.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
NOTICE
Ź7KLVSURGXFWLVDOVRGHVLJQHGIRU,7SRZHUV\VWHPVZLWKDSKDVH
to-phase voltage of 220 to 240 V.
Fastening the adapter cover
:KHQXVLQJWKH86%ZLUHOHVVDGDSWHUEH
sure to connect the adapter to the further
USB
TYPE A
port from the
LAN
port and use the
supplied adapter cover.
1.
Loosen the screw (marked with triangle) on
the bottom left of the
USB TYPE A
ports.
2.
Insert the tab of the cover into the hole at the upper right of
the
USB TYPE A
ports in the direction of the arrow.
3.
Align the screw holes on the projector and the cover. Then
insert the screw removed from the projector into the hole and
tighten the screw.
WARNING
Ź.HHSVPDOOSDUWVDZD\IURPFKLOGUHQDQG
pets. Take care not to put in the mouth.
Ź+HDWPD\EXLOGXSLQWKH86%ZLUHOHVVDGDSWHUWRDYRLG
possible burns disconnect the projector power cord for 10
minutes before touching the adapter.
3
1
2
Tab
AC
Power
cord
