INSTALLATION
3 - 5
DSE-17
www.maxcess.eu
MI 1064 1 C
Electrical connection
ATTENTION:
The sensor could be damaged.
The safe function of the sensor and the system is only
guaranteed if it is properly installed.
Electrical connections should always be made or disconnected
on the sensor while there is no electrical power in the system.
When attaching the connector with the jack on the sensor,
pay close attention to the guide and groove! The connector and
jack must not be connected with incorrect orientation or by
force, as this will destroy the sensor.
Electrical lines must not be subjected to any mechanical
loads.
∙
The sensor must be connected to the web guide controller
according to the system diagram in the system
documentation.
Note:
Normally the sensor must be connected to the web guide
controller with a cable on the corresponding sensor input. In
some cases the sensor can be connected via a Y-cable or an
external distributor box to two sensor inputs on the web guide
controller.