1. Use the MODE select button to select AUTO.IN the multi system, to avoid mode conflict, auto-mode is taken as cool
mode.
2. Push the TEMP button to set the desired room temperature. The most comfortable temperature settings are between
21°C
to 28°C
.
3. Push the ON/OFF button to start the air conditioner. The OPERATION lamp on the display panel of the indoor unit lights.
The operating mode of AUTO FAN SPEED is automatically set and there are no indicators shown on the display panel of
the remote controller.
4. Push the ON/OFF button again to stop the unit operation.
NOTES
1. In the AUTO mode, the air conditioner can logically choose the mode of COOL, FAN, HEAT and DRY by sensing the
difference between the actual ambient room temperature and the set temperature on the remote controller.
2. If the AUTO mode is not comfortable for you, the desired mode can be selected manually.
COOL, HEAT, and FAN ONLY Operation
1. If the AUTO mode is not comfortable, you may manually override the settings by using COOL, DRY, HEAT (heating
cooling systems), or FAN ONLY modes.
2. Push the TEMP button to set the desired room temperature. When in COOLING mode, the most comfortable settings are
21°C or above. When in HEATING mode, the most comfortable settings are 28°C or below.
3. Push the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.
4. Push the ON/OFF button. The operation lamp lights and the air conditioner starts to operate per your settings. Push the
ON/OFF button again to stop this unit operation.
NOTE: The FAN ONLY mode cannot be used to control the temperature. While in this mode, only steps 1, 3 and 4 may be
performed.
DRY Operation
1. Push the MODE button to select DRY.
2. Push the TEMP button to set the desired temperature from 21°C to 28°C.
3. Push the ON/OFF button. The operation lamp lights and the air conditioner starts to operate in the DRY mode. Push the
ON/OFF button again to stop this unit operation.
NOTE: Due to the difference of the set temperature of the unit and the actual indoor temperature, the Air Conditioner when
in DRY mode will automatically operate many times without running the COOL and FAN mode.
TIMER Operation
PUSH TIMER button to set the on and off times of the unit.
1. To set the STARTING time.
1.1 Please push the CANCEL button to cancel any former settings.
1.2 Push the TIMER button. The remote controller will show the TIMER and the signal "h" is shown on the display panel.
The control is now ready to reset the TIMER ON to start the operation.
1.3 Push the TEMP button (
▲ or ▼) to set desired unit START time.
1.4 After setting the TIMER there will be a one-half second delay before the remote controller transmits the signal to the Air
Conditioner. Then, after approximately another 2 seconds, the set temperature will re-appear on the digital display.
2. To set the STOPPING time.
2.1 Please press the CANCEL button to cancel any former settings.
2.2 Push the TIMER button and the remote controller will show the last set time for the START operation and the signal "h"
will be shown on the display panel. You are now ready to readjust the TIMER OFF to stop the operation.
26
