4.4. Names and functions of indicators on the remote controller display
AUTO
COOL
DRY
HEAT
1
6
2
3
4
5
FAN
HIGH
MED
LOW
Fig. 2
①
TRANSMISSION Indicator: This indicator lights when remote controller transmits signals to indoor unit.
②
MODE Display: Shows the current operation modes -- AUTO, COOL, DRY and HEAT. HEAT only available for heat
pump model.
③
LOCK display is displayed by pushing the LOCK button. Push the LOCK button again to clear display.
④
TIMER Display: This display area shows the settings of TIMER.
That is, if only the starting time of operation is set, it will display the TIMER ON. If only the turning off time of operation is
set, it will display the TIMER OFF. If both operations are set, it will show TIMER ON OFF which indicates you have chosen
to set both the starting time and off time.
⑤
FAN Display: When the FAN button is pushed, this signal indicator lights.
⑥
Digital Display Area: This area will show the temperature and, if in the TIMER mode, will show the ON and OFF
settings of the TIMER.
NOTE: All items are shown in the Fig. 2 for the purpose of clear presentation But during the actual operation only the
relative functional items are shown on the display panel.
4.5. Operating the remote controller
Install / Replace Batteries
The Remote Controller uses two alkaline dry batteries (R03/Ir03X2).
1. To install batteries, slide back the cover of the battery compartment and install the batteries according to the directions (+
and -) shown on the Remote Controller.
2. To replace the old batteries, use the same method as mentioned above.
NOTE
1. When replacing batteries, do not use old batteries or a different type battery. This may cause the remote controller to
malfunction.
2. If you do not use the remote controller for several weeks remove the batteries. Otherwise battery leakage may damage
the remote controller.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no answering beep from the indoor unit or if the Transmission Indicator light fails to
appear.
AUTOMATIC OPERATION
When the Air Conditioner is ready for use, switch on the power and the OPERATION indicator lamp on the display panel of
the indoor unit starts flashing.
25
