8
8
Building Your Double Trouble
9.
Tail Feathers. First step is to place the tailplane in position and then mark and remove a triangular
section of the film from both sides of the tail plane so that the glue can stick to the balsa correctly. Make
this slightly smaller on the top to the bottom as the fin fairings are slightly smaller than the tail plane seat
on the fuselage. When cutting the film cut approx 1mm inside of your marked line so no wood shows and
make sure not to cut the wood underneath as this could weaken the tailplane.
10. Make sure the tail plane sits square on the fuselage and then glue in place using 5 or 30 minute
epoxy and pin in place Fit the elevator control horn.
Summary of Contents for Double Trouble Balsa Pro-Built Series
Page 1: ...Instruction Manual ...
