9
Fig. 7
look from stern to stem. If the shaft rotates clockwise, the rotation is right-handed;
by contrast, if it rotates counterclockwise, the rotation is left-handed). In order to
change rotation of the MAX PROP
®
WHISPER, from right-hand rotation to left-hand
rotation or vice versa, operate as follows referring to fig. 7.
• Unscrew the screws locking the zinc, and remove the zinc.
• Unscrew the screws locking the nut, and remove the nut.
• At the aft edge of the hub there is a Seeger ring: remove it.
• Remove the transmission ring on which the zinc is fixed (zinc-holding ring).
• Once the zinc-holding ring has been pulled out, you can see there is an engraving on
one tooth of the hub (aft side), and two teeth of the zinc-holding ring are marked
with “L” (left) and “R” (Right), respectively.
• If you reassemble the zinc-holding ring, placing the tooth “R” at the tooth of the hub
where the engraving is stamped, you will have a right-hand propeller, if you rather insert
the ring placing the tooth “L” at the tooth of the hub where the engraving is stamped,
you will have a left-hand propeller (see fig. 7).
• Insert the Seeger ring in its seat.
• Screw the nut and lock it with the nut-locking screws.
• Put back the zinc, and fasten it with the three special screws.
BULINO DI RIFERIMENTO
REFERENCE MARK
VITI DADO
NUT SCREWS
ZINCO
ZINC
DADO -
NUT
SECURITY RING “SEEGER”
ANELLO DI SICUREZZA “SEEGER”
ANELLO TRASMISSIONE MOTO e ANELLO PORTA ZINCO
TRASMISSION MOVEMENT RING and ZINC-BEARING RING
MOZZO
HUB
VITI ZINCO -
ZINC SCREWS
B
