Seite 16 von 20
DOK-ID: WDX01G02, BE # 5100060
3.3.2. Disinfection
Only use wipe disinfection.
No liquid may penetrate the product.
The applied reprocessing process must comply with the applicable legal regulations and
guidelines.
Hygiene procedures and conditions are the responsibility of the operator and must be
determined by him.
Ensure that the materials used are compatible (e.g. stainless steel, aluminum, plastic,
lead acrylic, lead glass, PVC, natural, silicone or synthetic rubber, chromed, painted,
or coated surfaces).
In case of doubt, test the product suitability in an inconspicuous place.
CAUTION
Surface Damage
The combined use of different disinfectants and/or disinfectants and cleaning
agents may impair the product performance or damage surfaces of the
product.
Only valid for WD261: Disinfection
ComforTex®
HPMF Curtain
Prior disinfection, you always should perform cleaning.
CAUTION
Damage of Product
Do not use alcohol-based disinfectants, pure alcohol (e.g. ethanol and
isopropanol), or oxidizing as well as active chlorine or salt-containing
disinfectants as they attack the surface of the outer material more
strongly than disinfectants based on other chemicals.
Avoid applying too much pressure while disinfecting. To maintain the properties of our radiation
protection products, we recommend the use of the following disinfectants. Please observe the
instructions below:
The tests carried out at our company do not correspond to any certified or standardized
test procedures, so that we cannot issue a release, but only a recommendation.
Since we have no influence on the production as well as the raw materials of the
disinfectant, we have to decline any guarantee on the resistance of our protective products
to the disinfectant.
The effectiveness of the surface disinfectant has not been considered. The instructions for
use of the disinfectant must be adhered to.
For the reasons mentioned above MAVIG excludes any warranty or liability for subsequent
damages.
Disinfectant
Manufacturer
Effective base
Microbac forte
BODE Chemie GmbH
Quaternary compounds, alkylamine derivative
Kohrsolin FF
BODE Chemie GmbH
Aldehyde, quaternary compounds
Antifect FF
Schülke & Mayr GmbH
Quaternary compound, aldehyde
Microzid Sensitive Wipes
Schülke & Mayr GmbH
Quaternary compounds
Microbac Tissues Solution
BODE Chemie
Quaternary compounds
In general, when choosing a disinfectant, make sure it contains as few alcohols as possible.
Ideally, the first 5 ingredients should not be alcohols or these should be listed with amounts
of „< 5%“.
