The Guardian Manual
7 |
P a g e
Rev. 01 | December 2017
PART 3: OPERATIONAL INSTRUCTIONS
3.1 EQUPMENT OPERATION
1)
Always check that the power supply and the equipment is at the same voltage and that the current of the power air
breaker is a little bigger than safe current of the equipment.
2)
Adjust the handle bar to be straight to the floor and then use one foot to touch the pedal and two hands to grasp the
handle bar to slowly pull back the equipment to the floor.
3)
Change the diamond tools or resin pads as shown in “Figure 1”.
4)
Slowly pull down the equipment to the floor.
a.
NOTE: This step must be performed slowly to avoid damaging the machine.
5)
Plug into the power; the LED display will show voltage of the connected power. If the voltage is not the same as the
equipment, please do not start the machine. If it is the correct voltage, proceed to the next step.
6)
Adjust
the handle bar to a comfortable position and press “ON” to start the machine.
7)
When grinding, we recommend using 800-900 RPM. If polishing, we recommend 1,200-1,300 RPM.
a.
NOTE: while the above recommendations are provided, you should always review the floor and tools
specifications.
8)
If you attach PCD, when the machine runs in the “Forward” direction, attach PCD
-R. If you run the machine in the
“Reverse” direction, attach PCD
-L.
Figure 1
3.2 EQUPIMENT STORAGE AND MAINTENANCE
1)
Adjust the handle bar to be straight to the floor, and remove the plug from the power.
2)
Check the machine and accessories to ensure that they are safe and in good working condition. If not, make any
necessary repairs and conduct maintenance before storage.
3)
Clean the plate, flange and machine appearance. Check all the cables and tighten all screws before storage.
4)
Keep the machine in a dry place.
5)
Change the oil after 1 year or ½ year, according to how often you use the machine.
3.3 NOTES FOR TRANSPORTATION
1)
Before
carrying the machine, make sure the power switch is in the “Off” state, and that there is no water left in the
water tank.
2)
Push lightly and carefully so as to avoid any damage to the machine or its parts, especially when it is against a wall.
3)
Before transportation, make sure to pack all the parts, diamond tools, etc. together to avoid losing any parts.
4)
After using the lifting rods, place them back to their storage location.
Summary of Contents for Guardian
Page 1: ......
