The Guardian Manual
4 |
P a g e
Rev. 01 | December 2017
PART 1: SAFETY & PRECAUTIONS
1.1 SAFETY GUIDE
1)
The operator must wear waterproof, insulating work shoes and gloves. Barefooted operation is strictly prohibited.
2)
The external connecting wire should be better more than 4m2 and must be connected with the earth wire to avoid
the electric leakage.
3)
Before using the equipment, the operator needs to inspect that the power wire is not damaged or aging. If so,
immediately replace the power wire to avoid short circuiting and electric leakage.
4)
Personnel sitting on the top of motor is prohibited at all times. The Motor is IP55, which could work after spraying a
little water and could work on wet grinding and polishing surfaces. Do not operate outside on a rainy day.
5)
Do not put the equipment, the power plug and socket on a watery or over-humid floor.
6)
Do not crush the cables when operating or when storing the equipment.
7)
Ensure that the plug and your hands are dry when connecting to power. Never connect when any part of your body
is wet.
8)
After connected to the power source, the inverter display will show the power voltage. If the power voltage is not the
same as the equipment voltage, do not start the equipment. Doing so will burn the inverter.
a.
For Example: if the machine is 200-240V after connecting to the power source and the inverter display shows
380V or any other data over 240V, do not start the machine.
1.2 NOTICE
1)
After dry grinding and wet grinding, it is best to clean the flange part and plate. This should increase the service life
of the equipment.
2)
Connect to a vacuum when dry grinding and polishing to reduce the spreading of dust particles.
3)
When you need to change the diamond tools and resin pads, adjust the handle bar to a vertical position, and then
gently pull back the equipment and make sure the equipment is stable. After changing the tools, make sure to pull
the equipment down gently. Aggressively pulling down on the equipment may destroy the equipment or cause oil
leakage.
a.
NOTE: If one person cannot handle the equipment safely and with ease, seek assistance. This is for your
safety and for the safety of the equipment.
4)
The equipment has a set the motor protection system. If the equipment is overloaded or has lower voltage, the
equipment will stop working immediately by itself in order to protect the motor and inverter. Simultaneously, the
inverter will show an error data on the display.
a.
NOTE: If this occurs, contact Maverick Surface Preparations, LLC for instruction on how to remove the error
data and solve the problem.
5)
If the floor is uneven, start grinding from the higher surface to the lower surface.
6)
Before operating the machine, carefully inspect the wire abrasion, plate screw and magnets, etc. After inspection is
complete and you are sure everything is safe and functional, you may begin to run the machine.
Summary of Contents for Guardian
Page 1: ......
