Mauldin M415XT MAINTAINER, Manual

Page: 13 / 78

2/3/2020 Page 13 of 78
Calder Brothers Corporation
Model: M415XT Maintainer
M415XT
Section C – Controls & Accessories
INSTRUMENT PANEL INDICATORS
1. Menu Button
2. Float Blade/Boom
3. Work Lights
4. Operator Mode Selector
5. Steering Mode Selector
6. Enlarge Review Camera
7. Float Pressure Settings
8. Regen Force/Inhibit
9. Beacon Light
10. Work Engine RPM Setting
11. Travel Mode Selector
12. Engine Coolant Temp Warning Light
13. Engine Oil pressure Warning Light
14. Hydraulic Oil Temp Warning Light
15. Regen Active Warning Light
16. Parking Brake Light
17. Bucket Level Angle
18. Fuel Level
19. DEF Level
20. Engine Tachometer
21. Speedometer
22. Machine Hours
23. Rear View Camera
FRAME/BODY INDICATORS
Hydraulic Reservoir Fluid Level –
The Sight Gauge is located on the side of the Reservoir. Note that you must retract all
cylinders. Having the hydraulic cylinders extended will cause the level in the hydraulic tank to be below the sight gauge
window. When all hydraulic cylinders are retracted there should be a “line” level of fluid in the sight gauge window.
Engine Oil Level - Refer to the Engine Manual for location. Pull out the Dipstick and wipe off. Re-insert and pull out to read
engine oil level.
Radiator Level - The Fill Cap is located on the top rear of the Engine Hood. CAUTION this Cap is pressurized.
Battery Fluid Level -
The Battery is located inside of the Engine compartment.
DRIVE FUNCTION CONTROLS
Engine Throttle
Engine Throttle is controlled by the computer. Press the Work Engine RPM Setting button (10). When the RPM
read out is flashing use the dial to increase or decrease desired working RPM. When you have the desired RPM
click the center button inside the dial. The engine IDLE RPM is predetermined at the factory. The machine will
automatically idle down when no functions are being used.
Dual Direction/Speed Control Pedal
Press the Foot Pedal forward for forward travel. Reverse depression enables backward travel. Speed is
determined by the distance the pedal is depressed.
Steering Mode Selector
The Steering mode selector is used to select which steering mode is desired. This machine has 2 steering modes. 2
wheel and 4 wheel steer. Press the Steering Mode selector for desired mode. The icon will flash. Turn the steering
wheel left or right until all 4 wheels are centered straight forward. The icon will stop flashing when the wheels are
centered and the machine will be in the desired steering mode.