mattke MDCA 100, Manual

Page: 22 / 36

22
4.0 Internal adjustements
The adjustments are located inside the converter. All calibration pins are mount on headers
spaced. It ‘better to use a resistors with 1/4 watt (10,16mm) pitch and the capacitors (5.08mm)
pitch.
Are also present, 11 solder bridges, through which you can enable or disable features or parts
of the converter. The converter in standard configuration (encoder feedback) is provided with
the following point closed (ON).
The following pages highlight the various settings to be implemented over the area of adjust-
ments to set the converter depending on the desired velocity feedback.
In the left-hand page for each chosen velocity feedback, is shown a typical connection with
the notes of wiring of the converter.




The adjustments are located inside the converter. All calibration pins are mount on headers
spaced. It ‘better to use a resistors with 1/4 watt (10,16mm) pitch and the capacitors (5.08mm)
pitch
Are also present , 11 solder bridges, through which you can enable or disable features or parts of
the converter. The converter in standard configuration (encoder feedback) is provided with the
following point closed (ON).
 
The following pages highlight the various settings to be implemented over the area of adjustments
to set the converter depending on the desired velocity feedback.
In the left-hand page for each chosen velocity feedback, is shown a typical connection with the
notes of wiring of the converter.