-9-
if Autonotify = 1, UCIMAG will send the message
“
TRACK DATA READY
”
as soon as the card
has been swiped. The user can then poll the data with :Tn command.
:Jb
- Include start (%) and end (?) characters in track data, if b=0 disable, if b=1 enable
:RTt
- Select Reader type (determines which card load signals to use)
0 = swipe,
1= half insertion using 2 sensors,
2= full insertion,
3= half insertion using only 1 sensor in back,
4= half insertion using 1 sensor in front,
5= half insertion with 2 s card load signal,
Returns: reader status
9.3 UCIMAG Status Commands
:SR
- Send reader status, its configuration
Returns: SR:ABCI.scnde.xyz.t.<sh><sl><CR><LF>
Where:
A=CardLoad1 signal = 0 or 1
B=CardLoad2 signal = 0 or 1
C=CardLoad3 signal = 0 or 1
I=CardInserted signal = 0 or 1
s=AutoSend configuration bit = 0 or 1
c=AutoClear configuration bit = 0 or 1
n=AutoNotify configuration bit = 0 or 1
d=direction configuration bit = 0 or 1 (1 = reverse)
e=UseStartEnd configuration bit = 0 or 1
x=Track 1 enable bit = 0 or 1 (1=enabled)
x=Track 2 enable bit = 0 or 1 (1=enabled)
x=Track 3 enable bit = 0 or 1 (1=enabled)
t=Reader Type character = 0,1,2,3 see RT command
:ST
- Send track status
Returns: <LF>ST:dsercc.dsercc.dsercc.<sh><sl><CR><LF>
Where:
d= data was detected on track
s= start character was detected
e = end character was detected
r = LRC check was passed
cc = two characters representing the hex value of byte count of track first set of
“
dsercc
”
is for track 1, second set is for track 2, and third set is for track 3
:V
- Send Firmware Version
Returns: Panasonic UCIMAG vx.xx Copyright xxxx
