Matrix U7xe-04, Service Manual

Page: 64 / 81

61
9.17 PUlley Axle SeT RePlACeMeNT - CoNTINUeD
fIgURe e
fIgURe D
fIgURe f fIgURe g
5) Remove the C-clip holding the bearing in place on the right side of the frame (Figure D).
6) Remove the bearing (Figure E).
7) Remove the 60 mm nut holding in the pulley axle assembly with a large channel lock pliers or a pipe wrench (Figure F).
8) Once the 60 mm nut is removed, the pulley axle set can be removed from the left side of the frame (Figure G).
9) Reverse Steps 1-8 to install a new pulley axle set. note: Be sure to re-tension the generator belt to 80 lbs.
10) Test the bike for function as outlined in Section 9.21.
CHAPTeR 9: PART RePlACeMeNT gUIDe