Matrix T7XI-01, Service Manual

Page: 114 / 137

111
10.6 TV ProGrammING INSTrUCTIoNS
Once the cardio equipment has been installed and proper power and cable wiring is provided, The Television must be programmed to the club's
channels and settings.
Auto Tuning
- An auto scan will search for channel signals from the coax cable. It will tune in all channels that provide a signal of sufficient
strength.
1. Press ENTER, 1, 0, 0, 1, ENTER on the number keypad to enter Manager Mode.
2. Press TV on the screen (Figure A).
3. Select the tuner type on the screen (Figure B).
4. Select the source on the screen (Figure C). If your source is digital, select ATSC or QAM and continue onto Steps 5-7 for TV programming.
If your source is analog, select Analog and skip to Steps 8-11 for TV programming.
5. Program the Start Channel and Stop channel on the screen (Figure D). This will set the range that the tuner will search for channels.
6. Press Start Scan to begin scanning (Figure E). Scan Started will be displayed on the bottom left hand corner of the screen (Figure F).
fIGUre b fIGUre a
fIGUre f fIGUre e
fIGUre C fIGUre d
CHaPTer 10: TreadmIll SPeCIfICaTIoNS aNd aSSembly GUIde