www.szmatrix.com
5
3.2
Pre-check
Please follow the steps below to check the power supply to ensure that the power supply can be used
normally.
1. Inspection
Please check if you have received the following accessories when you receive the power supply. If any are
missing, please contact your nearest dealer.
□ A power cord (conforms to the voltage standard used in the region)
□ An operation manual (standard configuration)
□ A warranty card (standard configuration)
2. Connect the power cord and turn on the power
After power-on, the power supply first conducts a system self-test test, and then enters the standby state.
Warning
: A three-core power cord is provided when the power supply is shipped from the factory. Your
power supply should be connected to a three-core junction box. Before operating this power supply, make
sure that the power supply is well grounded.
3.3 If the power fails to start
Use the following methods to solve the problems you may encounter when turning on the power.
1. Check if the power cord is connected
2. How to replace the fuse
Use a screwdriver to open the small plastic cover under the power input socket on the rear panel of the power
supply (as shown in the figure below), and you can see the fuse. Please use a fuse with the same specifications.
Model
Fuse specification
230V
115V
MPS-6005H-1
5A
8A
MPS-6010H-1
8A
15A
MPS-3010H-1
5A
8A
MPS-3020H-1
8A
15A
MPS-10003H-1
5A
8A
MPS-20002H-1
6A
10A
MPS-30001H-1
5A
8A
