MSC-XD0816L Product Manual
DestNames DEST, LEVEL, LABEL
Assign a label to a destination.
When querying names, labels are surrounded by double quotes and each level is separated by commas ',' (multi-
level systems only) and each destination is separated by newlines. Secondary levels use empty strings to
indicate that the label of the first level should be used.
Examples
>DestNames
“Dest1”,”AudDest1”
“Dest2”,””
“Dest3”,””
“Dest4”,””
>DestNames 1
“Dest1”,”AudDest1”
>DestNames 1,2
“AudDest1”
>DestNames 1,2,””
>
The first 3 example commands are query commands. The last assigns an empty string to the second level of the
first destination (thereby indicating that the first level label should be used).
3.11.3 DHCP Command
NOTE:
Superseded by the
net.dhcp
Query or assign DHCP enable. A value of 0 disables DHCP client support and will therefore use the manual
values assigned via the IP, Netmask and Gateway commands. A value of 1 enables DHCP and will obtain the
values for the IP address, Netmask and Gateway from your DHCP server. This value is saved and recalled on
power up.
WARNING:
A DHCP server must be present on your network for this to function properly. Using DHCP
allows for dynamic IP or fixed IP assignment from a central location (the DHCP server). Using this option is
only recommended if using fixed IP assignment by MAC address or if there is a way to determine what IPs the
Matrix Switch Corporation systems get assigned. Otherwise it may become difficult to determine what IP
address to use when accessing the Web Page or other control interfaces. In the event that the IP address or
Netmask of a system is unknown, consult the
section for this device.
Command
Description
DHCP
Query DHCP enable.
DHCP 0 | 1
Set DHCP enable (0 to disable, 1 to enable)
Examples to query and then enable DHCP
>DHCP
0
>DHCP 1
>
Page 28 of 61
© 2013-2018 Matrix Switch Corporation
