Matrix Switch Corporation MSC-CP32X1E, Product Manual

Page: 34 / 48

MSC-CP32X1E Product Manual
Command for disabling or enabling SDI reclockers. Not all router systems support this option. Value is saved
and recalled on power up.
Command Description
ReclkDis Query current value of reclocker disable.
ReclkDis 0 | 1 Enable or disable reclockers (0 or 1 respectively).
Examples
>ReclkDis
0
>ReclkDis 1
>
The first command above queries the current reclocker disable value which returns 0 (the default, reclockers
enabled). The second command disables the reclockers.
3.38 RemoteSync Command
Routers only - Protocol Version: 2.1
Command to enable syncing matrices of two router systems. Usually used for creating a 3D matrix from two
router systems, which will result in one router controlling the left 3D channels and the other router controlling
the right channels. When enabled, this option synchronizes matrix crosspoint changes to the router IP address
assigned with the
FrameIP Command . This command should only be enabled with one of the two routers (the
primary router). This value is stored and recalled on power up.
Command Description
RemoteSync Query current value of remote router syncing.
RemoteSync 0 | 1 Enable or disable remote router syncing (1 or 0 respectively).
Examples
>RemoteSync
0
>RemoteSync 1
>FrameIP 192.168.2.61
>
The first command in the above examples queries the current value of the remote sync option, which returns 0
(disabled, the default). The second command enables remote syncing and the final command sets the IP address
of the router to sync (secondary router).
3.39 S Command
Routers and MSC-GCP2U32 only
Query the current matrix routing state. Source values for all levels of every destination are shown. This
Page 34 of 48 Copyright © 2013-2015 Matrix Switch Corporation www.matrix-switch.tv