Matica Lamination Module MC-L2 User Manual
59
-Remove Jammed Card
1. Turn the power .
E31
Description
Error
Messages
Solution
E41
Please contact the service representative
promptly to avoid injuries.
(If this occurs when 'Initial', do not try
more than twice.)
The Sensor does not recognize the
mark on the
when starts lamination
process.
E42
The heater module fails to return
to its original position.
Description
Error
Messages
Solution
If the error message persists though the
cards are loaded, please contact the service
representative for assistance.
W10
Film near to end Warning : when
less.
Prepare the new
and replace the m
when the
is ended. The Error code for
is E22.
E26
If there is no card inside the laminator or
slot, the system goes back to normal. If the
problem persists, please contact the service
representative for assistance.
Jam occurs when there is no lamination
process.
and eject the card rotating knob on the
backside. If the problem persists, please
contact the service representative for
assistance.
Jam occurs during the lamination process
W11
Cleaning Warning : When the reaming
counts are to 40 cards or less and
laminated cards count is over 500
times after the last cleaning.
W30
Cleaning Warning : when the laminated
card count is over 500 times after the
last cleaning
Clean the inside of laminator refer to
page 63.
'Clean Roller Using Cleaning
card'
Clean the inside of laminator refer to
page 63.
'Clean Roller Using Cleaning
card'
