MATELEC AUSTRALIA. P 1800 281 282. F 1300 281 282
[email protected]. WWW.MATELECAUSTRALIA.COM.AU
SETTING THE CONTROLS
1.
Put the LUX control knob to light (
) position, turn the wall switch on and wait half a minute for
the control circuit to stabilize. At this stage ensure that the TIME control knob is set at minimum
duration time (-) position. The connected circuit will now switch on and remain on for about 30
seconds (within 60 seconds).
2.
Have another person move across the desired perimeter of the area to be scanned and slowly
adjust the SENS knob until the unit activates. Note reducing SENS will reduce both normal and
occupancy zones
3.
To set the light level at which the lights will automatically switch “on” at night, turn the LUX con
trol knob from daylight (
) to night (
). If the lights are required to switch on earlier, e. g. Dusk,
wait for the desired light level, and then slowly turn the LUX control knob towards daylight while
someone walks across the center of the area to be detected. When the lights activate, release
the LUX control knob. You may need further slight adjustments to achieve your ideal light level
setting
4.
Once LUX and SENS are calibrated, adjust TIME to suit site requirements.
5.
Duplicate these settings for similar locations
Fig 3
