Matelec FMS-12080 Instructions Download Page 2

Page: 2 / 4

MATELEC AUSTRALIA. P 1800 281 282. F 1300 281 282

[email protected]. WWW.MATELECAUSTRALIA.COM.AU

Fig 1

INSTALLATION

Exceeding the maximum rated load may cause overheating and probable failure of this sensor. Please

exercise care!

SURFACE MOUNT TO CEILING (Fig 1)

Remove the front cover

Unscrew the cable clamp, and remove the Junction Box and Terminal Block

Use the Base as a template to mark the screw holes into the ceiling. Pre-drill the lining to depth of

35mm and fit the plastic plugs, and then affix the Base securely. Care should be taken to avoid

drilling or screwing any concealed services inside the ceiling void.

Connect circuit wiring to the terminal block as labeled.

Secure the Junction box & Terminal block to the PIR and tighten cable clamp over Mains Cable.

Carefully align the male terminal pins, click the PIR body onto the Base then re-fit the front cover.

Note:

All electrical connections relating to this installation must be carried out by a suitably qualified and

registered electrician.

Summary of Contents for FMS-12080

Page 1: ...or a user determined period of time An integral daylight sensor ensures day or night only operation SPECIFICATIONS Power Source 220V 240VAC Power Frequency 50HZ Time delay Min 5 seconds Max 40 minutes...

Page 2: ...rew holes into the ceiling Pre drill the lining to depth of 35mm and fit the plastic plugs and then affix the Base securely Care should be taken to avoid drilling or screwing any concealed services in...

Page 3: ...reduce the duration time Note Once the circuit has been triggered by the PIR sensor any subsequent detection will start the timed period again from the beginning SENSITIVITY SETTING REACH The sensiti...

Page 4: ...lowly adjust the SENS knob until the unit activates Note reducing SENS will reduce both normal and occupancy zones 3 To set the light level at which the lights will automatically switch on at night tu...