MSC4RFA17
2
Rev. 08/04/17
MSC4RFA17
Deluxe Service Cart
Due to the weight of this cart we recommend that
TWO PEOPLE
work together on the assembly. This cart
weighs approximately 170 lbs; please use caution during
assembly.
Step 1:
Locate the key tied to the bottom tray. Using the key,
open the lid and remove the caster box from the
bottom drawer. Once removed, make sure all drawers
are completely closed and the inside lever is in the
locked position. Close the top lid and lock.
Step 2:
Lay out a work surface using the protective foam
provided. Once this surface is secure, gently turn the
cart onto its lid (logo will be facing the foam).
Step 3:
(Before assembling the legs, remove the cable tie
holding the bumper in place.) Insert the front leg
(Part #7), labeled FL or FR into top lip of the cart. Then
place the Front bumper (Part # 14 with Matco Logo)
over the leg aligning the center bolt holes. With holes
aligned, insert stove bolt (Part #1a) and finger
tighten with nyloc nut and washer.
Step 4:
Install back leg (Part #7) labeled BL or BR and bumper
(Part #14 without logo) following the same procedure
as above. Note: Make sure the back leg is inside the
hinge rivet. Otherwise the holes will not line up
during assembly!!!
Step 5:
Repeat steps 3 & 4 to mount the legs on the
opposite side.
Step 6:
Completely tighten the 8 bolts just inserted.
ASSEMBLY INSTRUCTIONS
1a
1a
14
7
1a
14
7
