Page 7 of 20
1910308-12
POWER INDICATOR LIGHT
In the “OFF” position, no power is being supplied
to the torch. In the “ON” position, power is
supplied to the main transformer and control
circuit.
ALARM INDICATOR LIGHT
If the duty cycle of the welder is exceeded, the
internal temperature will exceed safe
temperatures and the machine will shut down.
The thermal overload light will come on indicating
this. Leave the unit on and allow 15 minutes for
cool down before the light will go off and the
temperature to fall into an allowable operating
range.
WORK LIGHT
This means the machine is working and the
machine is welding and under load.
WIRE FEED SPEED CONTROL
Adjustment of the wire feed speed. Refer to the
"set up" chart inside the wire feed compartment
for initial adjustment settings.
WELDING VOLTAGE CONTROL
The voltage control is on the front panel of
machine. Refer to the “set up” chart inside the
wire feed compartment for initial adjustment
settings.
GROUND CABLE AND CLAMP
The ground cable and clamp are attached to the
work piece to complete the circuit allowing the
flow of current needed to weld.
MIG TORCH
The welding wire is driven through the welding
cable and torch to the work piece. It is attached to
the drive system. The trigger activates the drive
motor.
INERT GAS REGULATOR AND HOSE
The Inert Gas Regulator installs on the shielding
gas cylinder for MIG welding with solid wires. The
regulator controls compressed gas and allows
adjustment flow rate of the gas. The gas hose
connects to the regulator/flow gauge and delivers
the shielding gas from the shielding gas bottle to
the welder.
POWER CORD AND PLUG
Plug this unit into a 120V, 20-amp circuit
breaker power supply.
FLUX CORE NOZZLE AND CONTACT TIPS
The flux core nozzle is used during flux core
Welding
Voltage Control
Ground Cable
And Clamp
MIG
Torch
Power
Indicator
Wire Feed
Speed Control
Work
Light
Inert Gas
Hose
Inert Gas
Regulator
Flux Core Nozzle and
Contact Tips
Alarm
Light
Power
Cord
