background image

MFLCOB2 2W COB Folding Light

MFLCOB2  5 11/14/14

sAVe tHese instructions!

SAFETY INSTRUCTIONS FOR BATTERY 

CHARGER AND BATTERY PACK

dAnger! reAd cArefully
120 Volts present at charging terminal. Absolutely do not 

probe with conductive objects.

1.   CAREFULLY READ AND UNDERSTAND THESE INSTRUCTIONS 
 

This manual contains critical safety and operating instructions  

 

for the light, battery charger, and battery.

2.   Before using battery charger, read all instructions and  

 

cautionary markings on (1) battery charger, (2) battery, and  

 

(3) product using battery.

3.   CAUTION - To reduce risk of injury, charge only MATCO  

 

rechargeable batteries marked on the charger label. Other  

 

types of batteries may burst causing personal injury and  

 damage.
4.   Do not expose charger to rain or snow.
5.   Use of an attachment not recommended or sold by Matco  

 

or the battery charger manufacturer may result in a risk of  

 

fire, electric shock, or injury to persons.

6.   To reduce risk of damage to electric plug and cord, pull by   

 

plug rather than cord when disconnecting charger.

7.   Make sure cord is located so that it will not be stepped on,   

 

tripped over, or otherwise subjected to damage or stress.

8.   An extension cord should not be used unless absolutely  

 

necessary. Use of improper extension cord could result in  

 

a risk of fire and electric shock. If extension cord must be  

 

used, make sure:

 

a.   That pins on plug of extension cord are the same  

 

 

number size, and shape as those of plug on charger;

 

b.   That extension cord is properly wired and in good  

 

 

 

electrical condition;

 

c.   That wire size is at least as large as the one specified  

 

 

in the table below.

table 1: recoMMended MiniMuM Awg siZe for   

eXtension cords for bAttery cHArgers

Length of Cord (Feet) 

25 

50  75  100  150

AWG Size of Cord  

18 

18  16  14  12

9.   Do not operate charger with damaged cord or plug -  

 

replace them immediately.

10.  Do not operate charger if it has received a sharp blow,  

 

been dropped, or otherwise damaged in any way; take it  

 

to a MATCO AUTHORIZED service facility.

11.  Do not disassemble charger or battery cartridge; take it to  

 

your MATCO AUTHORIZED distributor service facility.  Incorrect  

 

reassembly may result in a risk of electric shock or fire.

12.  To reduce risk of electric shock, unplug charger from outlet  

 

before attempting any maintenance or cleaning. Turning off  

 

controls will not reduce this risk.

13.  The battery charger is not intended for use by young children  

 

or infirm persons without supervision.

14.  Young children should be supervised to ensure that they do  

 

not play with the battery charger.

OPERATIONAL GUIDELINES 

FOR BATTERY CHARGER AND

BATTERY PACK

1.   Do not attempt to use a step-up transformer, an engine  

 

generator or DC power receptacle.

2.   Do not allow anything to cover or clog the charger vents.
3.   Always cover the battery terminals with the box or cover  

 

when the battery cartridge is not used.

4.   Do not short the battery cartridge:
 

a.   Do not touch the terminals with any conductive material.

 

b.  Avoid storing battery cartridge in a container with other  

 

 

metal objects such as nails, screws, coins, etc.

 

c.   Do not expose battery cartridge to water or rain. A battery  

 

 

short can cause a large current flow, overheating, possible  

 

 

burns and even a breakdown.

5.   Do not store the light and Battery Cartridge in locations  

 

 

where the temperature may reach or exceed 

 

50°C (122°F).

6.   Do not incinerate the Battery Pack even if it is severely  

 

damaged or is completely worn out. The battery cartridge  

 

can explode in a fire.

7.   Be careful not to drop, shake or strike battery as it will affect  

 

the capacity and may void warranty.

8.   Do not charge inside a box or container of any kind. The  

 

charger and battery are ventilated devices and must NOT be  

 

placed next to a heat source or in exposure to radiating heat. 

9.  Place charger on a solid and sturdy surface as there are    

 

vents on the bottom side of the charger.

10.  Always unplug the charger from the power supply when a    

 

charging sequence is not taking place. 

FAILURE TO OBSERVE THESE WARNINGS COULD RE SULT IN IN JU RY.

WARNING

Summary of Contents for MFLCOB2


















Reviews: