Matco Tools MCL1238RA Operating Instructions Manual Download Page 5

MCL1238RA, - G, - O 

rev.  06/06/19

MCL1238RA 12V 3/8" High Speed Ratchet

SAVE THESE INSTRUCTIONS!

SAFETY INSTRUCTIONS FOR BATTERY 

CHARGER AND BATTERY PACK

DANGER! READ CAREFULLY
120 Volts present at charging terminal. Absolutely DO NOT 
probe with conductive objects.

1 . CAREFULLY READ AND UNDERSTAND THESE INSTRUCTIONS 
This manual contains critical safety and operating instructions 
for the tool, battery charger, and battery .
2 . Before using battery charger, read all instructions and 
cautionary markings on (1) battery charger, (2) battery, and (3) 
product using battery .
3 . CAUTION - To reduce risk of injury, charge only MATCO 
rechargeable batteries marked on the charger label . Other 
types of batteries may burst causing personal injury and 
damage .
4 . Do not expose charger to rain or snow .
5 . Use of an attachment not recommended or sold by Matco or 
the battery charger manufacturer may result in a risk of fire, 
electric shock, or injury to persons .
6 . To reduce risk of damage to electric plug and cord, pull by 
plug rather than cord when disconnecting charger .
7 . Make sure cord is located so that it will not be stepped on, 
tripped over, or otherwise subjected to damage or stress .
8 . An extension cord should not be used unless absolutely 
necessary . Use of improper extension cord could result in a 
risk of fire and electric shock . If extension cord must be used, 
make sure:
 

a .   That pins on plug of extension cord are the same   

 

    number size, and shape as those of plug on charger;

 

b .   That extension cord is properly wired and in good   

 

    electrical condition;

 

c .   That wire size is at least as large as the one specified  

 

    in the table below .

 

Table 1: RECOMMENDED MINIMUM AWG SIZE FOR    

 

EXTENSION CORDS FOR BATTERY CHARGERS

Length of Cord (Feet)  

25   50   75   100  150

AWG Size of Cord  

18   18   16   14    12

9 . Do not operate charger with damaged cord or plug - replace 
them immediately .
10 . Do not operate charger if it has received a sharp blow, 
been dropped, or otherwise damaged in any way; take it to a 
MATCO AUTHORIZED service facility .
11 . Do not disassemble charger or battery cartridge; take it to 
your MATCO AUTHORIZED distributor service facility . Incorrect 
reassembly may result in a risk of electric shock or fire .

12 . To reduce risk of electric shock, unplug charger from outlet 
before attempting any maintenance or cleaning . Turning off 
controls will not reduce this risk .
13 . The battery charger is not intended for use by young 
children or infirm persons without supervision .
14 . Young children should be supervised to ensure that they do 
not play with the battery charger .

OPERATIONAL GUIDELINES  

FOR BATTERY CHARGER AND 

BATTERY PACK

1 . Do not attempt to use a step-up transformer, an engine 
generator or DC power receptacle .
2 . Do not allow anything to cover or clog the charger vents .
3 . Always cover the battery terminals with the box or cover  
when the battery cartridge is not used .
4 . Do not short the battery cartridge:
 

(1)  Do not touch the terminals with any conductive    

     material .
 

(2)  Avoid storing battery cartridge in a container  

 

    with other metal objects such as nails, screws,  

 

    coins, etc .

 

(3)  Do not expose battery cartridge to water 

 

    or rain . A battery short can cause a large current flow,  

 

    overheating, possible burns and even a breakdown .

5 . Do not store the tool and Battery Cartridge in locations 
where the temperature may reach or exceed 50°C (122°F) .
6 . Do not incinerate the Battery Pack even if it is severely 
damaged or is completely worn out . The battery cartridge can 
explode in a fire .
7 . Be careful not to drop, shake or strike battery as it will 
affect the capacity and may void warranty .
8 . Do not charge inside a box or container of any kind . The 
charger and battery are ventilated devices and must NOT be 
placed next to a heat source or in exposure to radiating heat . 
9 . Place charger on a solid and sturdy surface as there are 
vents on the bottom side of the charger .
10 . Always unplug the charger from the power supply when a 
charging sequence is not taking place . 

FAILURE TO OBSERVE THESE WARNINGS COULD RE SULT IN IN JU RY.

WARNING

Summary of Contents for MCL1238RA




















Reviews: