Live Data Mode
RECORDING (CAPTURING) LIVE DATA
66 MD70
5.
Use the
UP
and
DOWN
buttons to scroll through the
available PIDs. When the PID you wish to record is highlighted,
press the
ENTER
button to select it. (a “checkmark” will show in
the checkbox to the right of the PID to confirm your selection).
Repeat the procedure until only the PIDs you want to record have all
been selected.
To deselect a currently selected PID, highlight the PID, then
press the
ENTER
button. The checkmark will be removed
from the checkbox.
6.
When you are finished making your selection(s), press the
LD
button to save your selection. Proceed to step
7
.
7.
If DTCs are presently stored in the
vehicle’s computer, an advisory message
displays. Use the
UP
and
DOWN
buttons, as necessary, to highlight Erase
DTCs, then press the
ENTER
button.
See ERASING DIAGNOSTIC TROUBLE
CODES (DTCs) on page 54.
8.
When the “Ready to Record” screen
displays, put the engine in the operating
condition that causes the DTC to set.
If necessary, drive the vehicle until you
reach the vehicle speed at which the
problem occurs.
9.
When the Scan Tool detects a fault that
causes a DTC to set, it automatically
records and saves approximately 100
frames of Live Data information in its
memory (according to your trigger selection)
for each PID supported by the vehicle.
All three LEDs will blink for three
seconds to indicate that Live Data is
being recorded, and a "One moment
please..." message shows on the
display, along with the number of the
frame being recorded.
When recording is complete, a
confirmation screen displays, asking if
you would like to view the recorded
data. Use the
UP
and
DOWN
buttons, as necessary, to select
Yes
or
No
, as desired, then press the
ENTER
button.