SAFETY GUIDELINES AND MEASURES
EN / Digital DC 10x10A / October 2010
5
2 SAFETY GUIDELINES AND MEASURES
2.1
WARNINGS AND SYMBOLS
Safety instructions and warnings are marked in this
manual by the following pictograms:
CAUTION
Special data, restrictions and rules with
regard to preventing damage.
WARNING
A WARNING refers to possible injury to
the user or significant material damage to
the charger if the user does not (carefully)
follow the procedures.
A procedure, circumstance, etc which
deserves extra attention.
2.2
USE FOR INTENDED PURPOSE
1 The
Digital DC 10x10A
is constructed as per the
applicable safety-technical guidelines.
2 Use
the
Digital DC 10x10A
only:
•
in a technical correct condition;
•
in a closed, well-ventilated room, protected
against rain, moist, dust and condensation;
•
observing the instructions in the users manual.
WARNING
Never use the Digital DC 10x10A in
locations where there is danger of gas or
dust explosion or potentially flammable
products!
3 Use of the
Digital DC 10x10A
other than
mentioned in point 2 is not considered to be
consistent with the intended purpose. Mastervolt
is not liable for any damage resulting from the
above.
2.3
ORGANIZATIONAL MEASURES
The user must always:
•
have access to the user's manual;
•
be familiar with the contents of this manual. This
applies in particular to this chapter, Safety
Guidelines and Measures.
2.4
MAINTENANCE AND REPAIR
1 If the electrical installation is switched off during
maintenance and/or repair activities, it should be
secured against unexpected and unintentional
switching on:
•
switch off all charging systems;
•
switch off the connection with the batteries;
•
be sure that third parties cannot reverse the
measures taken.
2 If maintenance and repairs are required, only
use original spare parts.
2.5 GENERAL
SAFETY
AND
INSTALLATION
PRECAUTIONS
•
Connection and protection must be done in
accordance with local standards.
•
Do not work on the
Digital DC 10x10A
or system
if it is still connected to a current source. Only
allow changes in your electrical system to be
carried out by qualified electricians.
•
Check the wiring at least once a year. Defects
such as loose connections, burned cables etc.
must be corrected immediately.
