Page 7
4. SPECIFICATIONS
Internal battery type ................................................................. Lithium Ion Polymer
Capacity ......................................................................................................... 29.6Wh
Nominal voltage ............................................................................................. 12V DC
Micro USB input .........................................................................................5V DC, 2A
USB output ..............................................................................................5V DC, 2.4A
Jump start ......................................................................1000A peak/500A cranking
Charging Temperature ......................................................32°F - 122°F (0 ˚C - 50 ˚C)
5. REPLACEMENT PARTS
Micro USB-USB charging cable .......................................................... 3899003781Z
6. CHARGING THE INTERNAL BATTERY OF THE JUMP STARTER
IMPORTANT: CHARGE IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE
AND EVERY 30 DAYS, TO KEEP THE
JUMP STARTER’S INTERNAL BATTERY
FULLY CHARGED AND PROLONG BAT-
TERY LIFE.
CHECKING THE LEVEL OF THE
INTERNAL BATTERY
Press the ON/OFF Power switch, and then
press the
Battery Status/Light
button on
the front of the unit. The LEDs will indicate
the current charge level as follows:
• Red LED flashing:
0-5% of full charge;
immediately charge the unit.
• Red LED solid:
6-49% of full charge.
• Yellow LED solid:
50-75% of full charge.
• Green LED solid:
76-100% of full charge.
CHARGING THE INTERNAL BATTERY
The jump starter will fully charge in 3-4 hours.
NOTE:
Use a 2A USB charger (not included),
or a 2A USB charging port to quickly
recharge the jump starter. Using a charger
with less than 2A will increase charge time.
1.
Plug the Micro USB end of a charging
cable into the input port. Next, plug the
USB end of the charging cable into your
charger’s USB port.
2.
Plug your charger into a live power
source.
3.
When the unit is charging, the three
LEDs will flash as follows:
• Red LED flashing:
0-49%
• Red LED solid and Yellow LED flashing:
50-75%
• Red and Yellow LEDs solid and Green
LED flashing:
76-99%
• Green LED solid:
100%
4.
Ten seconds after the battery has
reached full charge, the green LED will
turn solid.
5.
If the Red
Ready/Fail
LED lights and
the buzzer sounds, the unit’s protec-
tion has been activated (such as short
circuit protection, battery low voltage
protection, reverse polarity protection,
etc.) and the unit will not operate.
6.
When the battery is fully charged, dis-
connect your charger from the power
source and then remove the charging
cable from the charger and the unit. Make
sure the power switch is set to OFF, if
not using the jump starter immediately.