Page 8
7. OPERATING INSTRUCTIONS
JUMP STARTING A VEHICLE
IMPORTANT:
Using the jump starter with-
out a battery installed in the vehicle will
damage the vehicle’s electrical system.
1.
Turn the ignition OFF.
2.
Lay the DC cables away from any fan
blades, belts, pulleys and other mov-
ing parts.
3.
For a negative-ground vehicle (as
in most vehicles), connect the jump
starter’s POSITIVE (RED) clamp to
the POSITIVE (POS, P, +) battery post.
Next, connect the NEGATIVE (BLACK)
clamp to the vehicle chassis or engine
block, away from the battery.
4.
For a positive-ground vehicle, con-
nect the jump starter’s NEGATIVE
(BLACK) clamp to the NEGATIVE
(NEG, N, -) battery post. Next, connect
the POSITIVE (RED) clamp to the vehi-
cle chassis or engine block away from
the battery.
5.
Press the ON/OFF switch to turn on
the jump starter. The green
Ready
LED will light.
6.
It is best to wait 30 seconds after
clamp connection to attempt to start
the vehicle. Crank for up to 5 seconds.
If engine does not start, wait 30 sec-
onds before cranking again.
7.
After the engine starts, press the ON/
OFF switch to turn the jump starter off,
and then disconnect the black clamp (-)
and the red clamp (+), in that order.
8.
Recharge the unit as soon as possible
after each use.
USING THE USB PORT
The USB port provides up to 2.4A at 5V DC.
1.
Ensure the battery clamps are securely
clipped on the storage holders.
2.
Flip the ON/OFF power switch to turn
the unit ON.
3.
Plug your device into the USB port.
4.
Turn on the USB device.
5.
When finished using the USB port,
turn the switch to the OFF position.
6.
Recharge the unit as soon as possible
after each use.
USING THE WORK LIGHT
1.
Position the jump starter on a flat,
stable surface near the intended work
area.
2.
Ensure the battery clamps are securely
clipped on the storage holders.
3.
Flip the ON/OFF power switch to the
ON position.
4.
Press the
Battery Status/Light
button
on the front of the unit for 0.75 sec-
ond, to turn on the work light.
5.
When finished using the work light,
press the button for 0.75 second, to
turn off the work light.
6.
Recharge the unit as soon as possible
after each use.
ENERGY SAVING MODE
If the unit is not used after the ON/OFF
power switch is turned on, the unit will go
into Energy Saving mode after 10 minutes
to prevent battery discharge. Follow these
steps to use any function after Energy Sav-
ing mode:
1.
Press the ON/OFF power switch to
turn the unit ON.
2.
The Green
Ready/Fail
LED will light.
3.
After 10 minutes, the USB port and
Battery Status/Light
function will turn
off.
4.
After 10 minutes, the Green
Ready/
Fail
LED will turn off.
5.
Press the
Battery Status/Light
button
once. The unit is now ready for check-
ing the battery status and using the
jump starter, USB and work light.
